The development of science and technology has driven the progress of agriculture and aquaculture, so small feed pellet machines are also widely used in the majority of agriculture and farmers. However, some small feed pellet machines can discharge materials normally, while others cannot be used normally, but various situations will occur during use. The more common problem is the unstable output of the pellet machine after buying it home. The problem that the small feed pellet machine does not feed is actually not complicated, mainly due to several problems.
1: The problem of the mold plate, the new machine template you just bought needs to be run in, so the new machine needs to be run in with the feed with added oil (with 5 kg of feed, 1, 5 kg of fine sand, 2 kg of oil, no need to add water); general Under normal circumstances, the moisture of the feed should be controlled between 4-6%, adjust the gap between the pressing wheel and the template of the small feed pellet machine to make it about 1 mm, after adjusting the pressing wheel, the fixing bolts must be screwed tightly (if the template is empty) If it is blocked, you need to open it with a hand electric drill and then refill)
2: Check the knife edge and the filter screen. The gap between the knife edge and the filter screen must be suitable!
3: The motor of the small feed pellet machine is reversed, and the reverse rotation of the motor will be very dangerous and careful operation!
4. The discharge is sometimes out, sometimes out. This is generally not related to the forward and reverse rotation of the motor. It is good or bad, and it is related to the aging degree of the die plate of the small feed pellet machine.
