The raw material of sawdust wood briquette machine is sawdust, crop straw, wood branches, rice hull, bamboo sawdust, peanut shell, sunflower shell, furfural dregs, cotton stalks, corn stalks, sesame straw, corncob and shrubs broken branches,maize stalks, soybean stalks, broomcorn stalks, cotton stalks, rape stalks, peanut plants, sunflower stalks, bamboo sawdust, bagasse , wood chips , coffee husk, coir pith, jute sticks, Bamboo, wood, straw dust, Mustard stalk and cotton stalks ,nutshell, cocon and so on.
After the materials are crushed, they are dried and then shaped with a billet forming machine and then subjected to a carburizing treatment. The main equipments are: crusher, dryer, sawdust briquette making machine and carbonization furnace are produced with equipment arrangement.
Crusher: The raw materials are crushed into granules within 10mm by wood crusher.
Drying machine: it can automatically discharge the material and dry it again, the exhaust port does not cross the material, and the discharging port does not spray the material to fall naturally.It can be produced by four bar machines.
Sawdust briquette making machine: The density can be adjusted at any time. This technology not only guarantees the quality of products. Branches, leaves, sawdust and other agricultural raw materials are crushed, pressed and condensed, and because they can replace traditional charcoal, it is called "straw charcoal".
Carbonization Furnace: The fuel rods are carbonized and shaped from the rod making machine.
From raw material source to fuel use, the process is: material recovery → crushing → drying → automatic demineralization of feeding → billet making → carbonization → ejection → cooling → conveying → civil and small boilers → biomass power plant.
It is used in the compression molding of various biomass raw materials, with low energy consumption and high production efficiency
Change the old-fashioned movement bearing from 3 to 4, which increases the durability and stability of the machine.
Change the old-fashioned oil-coated lubrication to oil-immersed lubrication. As long as there is no shortage of oil, it can be used for many yearsIncrease the screw pitch and increase the amount of feed material, thereby greatly increasing the output.
The structure of the forming cylinder is improved, the friction between the machine and the raw material is reduced, and the density of the mandrel is increase.
The charcoal machine consists of a motor, large and small rollers, a head assembly, a bottom hopper, a screw propeller, a forming cylinder, a wear sleeve, a heating ring, a rod cutter and a control cabinet. The head always becomes the core of the whole machine, and it consists of the bearing, the main shaft, the casing and the lubrication chamber. The main assembly of our factory adopts original thrust bearings, and the lubrication system adopts oil-immersed lubrication, which largely ensures that the bearing quality and lack of oil will not cause equipment damage during the production process of the rod making machine.
Uses and characteristics of charcoal machine：
1.This product has the characteristics of reasonable design, reliable quality, simple structure, convenient operation, small size, small footprint, power saving and electricity saving.
The designed fully automatic control electric heating device can randomly adjust the dry humidity of the material to ensure the stability of the discharge molding and improve the work efficiency.
3. The main parts of this product are made of wear-resistant materials and are specially treated, which can be continuously pressed for production and are durable
