Using charcoal machine equipment to produce charcoal, after the raw materials are crushed, dried, and made into rods, carbonization is the last and more critical link. We need to put the prepared salary rods into the carbonization furnace for carbonization treatment, but in order to achieve the best carbonization effect of the salary rods in the carbonization furnace, the placement of the salary rods has also become a detail that we need to pay attention to, then , How do we place the prepared salary sticks so as not to affect the carbonization effect of the equipment?
In the process of carbonization, the fuel rod will go through three stages, namely drying stage, initial stage of carbonization, and comprehensive carbonization stage. Especially in the case of full carbonization, the temperature is high, which will produce a large amount of liquid products such as acetic acid, methanol and wood tar, and also produce flammable gases such as methane and ethylene. In order to make the carbonization of the salary rods more even, the salary rods must be placed evenly in the carbonization furnace, and should not be stacked randomly, and a space of about 50--100MM should be reserved near the salary rods so that the The water vapor can be released better, reducing the damage of the water vapor to the fuel rod in the carbonization stage, so that the fuel rod can be better heated and carbonized, and at the same time, it can prevent the fuel rod from being unable to be carbonized evenly during carbonization.
After evenly placing the formed fuel rods, we also need to control the carbonization temperature during the carbonization process. Generally, we can control the kiln temperature by adjusting the air inlet, and the stable heating and cooling process is the guarantee for burning high-density mechanism charcoal. Therefore, through the control of the above details, we can easily produce high-quality mechanism charcoal.
