1. The output of the feed pellet machine is too low or even no pellets or a lot of powder is produced. Although this problem does not occur often, if it occurs, it means that you did not grind the pressing wheel and grinding disc properly during the grinding process of the pellet machine. , the possible reasons for similar problems are the poor finish of the grinding hole when the grinding disc is used for the first time. After the grinding disc is ground with the abrasive or after a period of use, the output of the pellet mill will reach the normal output.
2. If the moisture content of the feed is not well controlled, it will also affect the output of the pellet machine. The moisture in the raw material should be controlled at 13%-20%, because the pellet machine has the function of drying and curing, and the moisture in the raw material is pressed by the pellet machine. It will be dried in the middle, and the pellets pressed by the pellet machine can be bagged after drying in the shade for 5-10 minutes at room temperature.
3. The gap between the pressing wheel and the grinding disc of the pellet machine is too large, which may also be one of the reasons why the pellet machine does not discharge. When the pressure rollers on both sides are not shaking with force and are a little tight, it means that the pressure rollers and the grinding disc have been adjusted in place.
These reasons may be the basic reasons for no pellets. Facing the frequent problems of feed pellet machines, our solution is also very simple. First of all, we need to optimize the grinding holes and let them adapt to the environment after working for a period of time. No, then it can be solved. If the feed moisture is too much, it can only be dried in the sun. If the moisture content is too small, appropriate amount of moisture needs to be added. Only when the raw materials are kept at a certain moisture, the drying and maturing function of the pellet machine can be exerted. The machine discharge can be very smooth.
