The use of the crusher needs to ensure the lubrication of the equipment, so as to ensure the normal operation of the equipment during operation. What do we need to pay attention to in the lubrication work.
1. In winter, thin oil can be added to the lubricating oil to prevent the lubricating oil from solidifying. After the addition, it must be sealed to prevent dust from entering and affecting the lubricating effect. Pay attention to the oil temperature of the lubricating oil when the crusher is working, and the oil temperature should not be too high and should be controlled below 60 degrees.
2. Before starting the crusher, add grease to the contact between the toggle plate and the toggle plate pad; change it every 3 to 6 months. When replacing the grease, clean the part of the bearing raceway with clean gasoline or kerosene. When cleaning, open the oil drain hole under the bearing seat and clean up all the parts before replacing it with new lubricating oil.
3. During the lubrication process, if the oil pump suddenly fails, and the crusher needs 15-20min to stop due to the large swinging force, the oil pump must be pressed by hand to keep the bearing lubricated and not to burn the bearing. .
4. Frequent attention and timely lubrication of the friction surface can ensure the normal operation of the machine and prolong the service life of the machine. Appropriate amount of grease should be added every 400 hours of work in production; the spindle should be opened to clean the bearings after every 2000 hours of work; new bearings should be replaced after every 7200 hours of work.
5. The bearing of the movable jaw suspension shaft of the crusher is usually lubricated with a butter cup, and the lubrication is about every 40-60 minutes.
For the lubrication work of the crusher, only after fully understanding, we can continuously make rectifications according to the condition of the equipment during the use process, do a good job in the lubrication of the crusher, and reduce the equipment due to the shortage of lubricating oil or the problem of adding to the equipment. Use impact.
