Fine crushing (medium and soft materials) - impact crusher. It adopts new manufacturing technology and special structural design. The finished product is cubic, without tension and cracks, and the grain shape is quite good. Stone (limestone, limestone, concrete, etc.), especially good at processing ore with low toughness and high brittleness, and the finished product has uniform edges and corners. It is a commonly used secondary crushing equipment.
Daily operation attention：
1. The crusher should be started under no-load conditions; the time of two jogs should not be less than 90 seconds, and the time of continuous jogs should not exceed 5 times.
2、The ore must be fed evenly, and the particle size should be table to the requirements.
3, always pay attention to slander ore and transport, so as not to blockage cause accidents.
4, often check the oil pump, cooler, filter and oil quantity oil temperature, return oil temperature should not exceed 60 ℃
5、Check the water seal dustproof drainage, if there is no water is not allowed to run.
6、Check the oil pressure of the locking cylinder carefully, the adjusting ring must be in the locked state before operation.
7、Check the liner wear regularly, pay special attention to the liner fixing bolts on the adjusting ring. If the loose plate is loose c new liner plate after 24h of work, should stop and tighten once.
8、Check the liner wear regularly, pay special attention to the liner fixing bolts on the adjusting ring. If the loose plate is loose c new liner plate after 24h of work, should stop and tighten once.
