The crusher is prone to a lot of heat problems after long-term use, but if the machine is too hot, it is easy to burn. Therefore, it is necessary to take the following measures to reduce its temperature. Therefore, we need to understand the cooling method of the crusher. Next, I will take you Let's take a look:
1. The oil film cooling of the rotor
In this cooling method, an oil pipe is connected to the inlet of the crusher to evenly drop the cooling oil to take away the heat of the rotor.
2. Air cooling
The so-called wet crusher is to compress the air sucked in two or two stages and then transport it through a combined muffler that integrates absorption and phase difference.
3. Water cooling
As the conveying and compressed gas crusher generates heat, the gas is transferred from the rotor to the housing and dissipated.
4. Cooling inside the rotor
In order to make the crusher work under a higher pressure difference, a more effective cooling method can be used, that is, the rotor is cooled by circulating oil, the oil hole and the shaft head are driven at both ends of the pump shaft, and then pass through the inner wall of the rotor from the other end discharge.
